Mach CN12 Operation & User’s Manual

20, Parallel system in passive mode CM12, CM15 and CM18 If you require more speakers for better sound distribution and you only have a limited number of output channels on your amplier, you can connect more than one speaker to each channel. This can be done by linking the speakers …

4, Introduction Thank you for purchasing a product from Mach Speakers A/S. Every effort has been made to ensure that our products meet your requirements and we sincerely hope that we will live up to your expectations. To get the most out of your Mach speakers and ensure an easy and trouble-…

18, Passive mode Active mode System conguration For maximum exibility, all Mach CM speakers can run either passive, using the built-in crossover, or active/biamped with direct drive of each transducer. The speakers are all set up as passive from the factory, but can easily be switched over to…

8, Mach CN12 Installation Your new Mach C-range speaker is one of the most versatile products on the market and every possible effort has been made to make it quick and easy to install your product. The many different installation options available will be described below. Mounting points on th…

23, 22 23 Amplier Sub Terminal on speaker In/Link In/Link In/Link Output Amplier LF Mains Input Output Mains Input Crossover M.20.06 1+/1- 1+/1- Output Mains Input Output Amplier HF Mains Input 2+/2- To Sub Triple-amp 3-way In a triple-amp 3-way system each transducer is run …

21, 20 21 Amplier Sub Terminal on speaker In/Link In/Link In/Link Output Amplier Mains Input Output Mains Input Crossover M.20.06 1+/1- 1+/1- Output Mains Input To Sub Bi-amp 3-way with Subwoofer In a bi-amp 3-way system the internal crossover is used for mid/high frequencies a…