Microtek C580 Operation & User’s Manual

12, Trouble-Shooting If you are experiencing difficulties with your monitor, check the following table for possible solutions. Problem Items to check ? No picture 1. The VGA card should be completely seated in the…

4, Installation 1. Turn off the computer. 2. Connect the video cable from VGA connector and audio line from output of the computer to the monitor. 3. Connect power cable to the power outlet. 4. Turn on the monitor and the computer. Wait about 30 seconds to adjust the picture with the adju…

10, Specifications LCD type 15.1 XGA Color TFT Input Signal Analog (0.7Vp-p/75 ohm positive) Dot Pitch 0.30 mm Scanning frequency (H) 31.5KHz-60KHz (V) 56Hz-75Hz Resolution 1024x768 800x600 832x624 640x480 720x400 640x400 640x350 Pixel Rate 80 MHz (maximum) Display Color 16.19…

8, Message of Video Input The message below will be displayed when horizontal and vertical synchronous signal from outside is off or out of acceptable range of this system. This message is erased in about 5 seconds and the system goes into the power saving mode. (1) No H_sync or V_sync input (2) H_syn…

11, Energy Declaration This monitor is equipped with a function for saving of energy which supports the VESA Display Power Management Signaling ( DPMS ) standard. This means that the monitor must be connected to which supports VESA DPMS to fulfill the requirement in the NUTEK specification. Time setti…