La Crosse Technology WS-8017U-MAH Instruction Manual

2, To display the alarm time in normal mode display Alkaline batteries are recommended for use in both units. Avoid using rechargable batteries. To exit the setting modes ATOMIC CLOCK LCD SCREEN DESCRIPTIONS The Atomic Clock's LCD is divided into 2 sections and once the bat…

3, La Crosse Technology WS-8017U-MAH LANGUAGE SETTING • • • • Date setting Weekday setting The weekdays can be displayed in LCD1 with the pre-set languages: US English, French and Spanish. 12/24 hour time display setting 1. Set the desired language for the weekday display in LCD 2 by use of the + key. ºC or ºF s…

8, LIABILITY DISCLAIMER: La Crosse Technology provides a 1-year warranty on this Atomic Clock. Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. • The manufacturer and supplier cannot accept any responsibility for any incorrect readings and a…

9, FCC ID: OMO-01RX (receiver) OMO-01TX (transmitter) THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 2. THIS D…

5, 3. Using other electrical products such as headphones or speakers operating on the same signal frequency (433MHz) may prevent correct signal transmission and reception. 4. Neighbors using electrical devices operating on the 433MHz signal frequency can also cause interference. …

7, TROUBLESHOOTING Problem: The LCD is faint. Solution: 1) Replace the batteries. Problem: No reception of WWVB signal Solution: 1) It may help reception to face the front of the Atomic Clock in the general direction of Ft. Collins, Colorado. 2) Wait overnight for signal. 3) Be sur…