Plextor PL-MAN2 Operation Manual

17, Plextor PL-MAN2 chances are that you aren’t using interrupt 11, and you can proceed confidently to step #3. 3) If you haven’t already installed your board, select an available 16-bit slot and insert the TMC-1610M board there (see page 21 for directions on how to install a board in your computer). 4) If…

16, ment if you need help in finding the proper device drivers for use with your SCSI interface board. Another source of device drivers for your CD-ROM drive is the growing number of ASPI driver programs such as Future Domain’s POWER SCSI, Adaptec’s EZ- SCSI and Corel’s CorelSCSI. These…

21, NOTE: The following section pertains only to PC users who use Microsoft’s Windows NT Operating System. Windows NT 3.1 YOUR TASK: Install Windows NT from your CD-ROM drive. Or, if you already have installed NT, add CD-ROM support. YOUR OBJECTIVE: Utilize full capabilities of NT on your…

14, The ‘‘16-bit’’ refers to the audio channel, not the SCSI data channel. The soundboard probably has only an 8-bit SCSI interface on it.) No matter which category your soundboard falls into, you will find that the best source of information about installing the soundboard in your computer …

4, Once you have successfully inserted the board, fasten it in place using the cover plate screw that you removed earlier. CHAPTER 8 ---- Hardware Installation PX-43CH/PX-45CH OPERATION MANUAL 23 …

22, 3) Run NT’s Setup program to add support for your SCSI interface board. Select ‘‘Add/Remove SCSI Adapters . . .’’ from the menu. Choose your SCSI inter- face board from the list or, alternately, add the driver you obtained from your SCSI interface board manufacturer. 4) Run the N…