Primera Accent II Operation & User’s Manual

16, 12 Maintenance and Troubleshooting C. TROUBLESHOOTING (continued) Problem Resolution There is a disc jammed in • Most likely the disc is not seated my Laminator - the tray properly in the tray. Clear the jam has stalled. by opening the top cover, and removing the disc from the laminator. If…

3, Primera Accent II iii Table of Contents Section 1: Getting Started..............................................................................................1 A. Choosing a Good Location...............................................................................1 B. Unpacking and Inspection .......…

8, 4 Getting Started D. APPLYING THE POWER 1. Locate the power cord supplied with your Laminator. 2. Place one end of the power cord into the power port located on the rear panel of the Laminator. 3. Plug the power cord into an available outlet. Avoid plugging your Laminator into a battery backup o…

11, Lamination Film and Optical Media 7 C. LAMINATING DISCS IN STAND-ALONE OPERATION Now that you have successfully loaded the Lamination Film, you are ready to laminate your discs. A. Turn the Laminator Power Switch to the ON position. Press the Laminate Button. The Disc Tray will automaticall…

10, 6 Lamination Film and Optical Media 2. Remove the Overlaminate Film and Take-Up Core from its packaging. The film comes pre-rolled on a core with a separate Take-Up Core included in the package. 3. Place the Take-Up Core in the front of the Laminator between the black plastic Ribbon Drive H…

2, Notices: The information in this document is subject to change without notice. NO WARRANTY OF ANY KIND IS MADE WITH REGARD TO THIS MATERIAL, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. No liability is assumed for …