Supermicro X5DL8-GG Operation & User’s Manual

42, Supermicro X5DL8-GG 2-18 SUPER X5DL8-GG/X5DLR-8G2+/X5DLR-8G2 User’s Manual GLAN1 Enable/Disable (X5DL8-GG) Change the setting of jumper JP54 to enable or disable the onboard LAN1 port on the motherboard. See the table on the right for jumper settings. The default set- ting is pins 1-2. Jumper Pos…

76, 4-22 SUPER X5DL8-GG/X5DLR-8G2+/X5DLR-8G2 User’s Manual 4-9 Security Setup Choose Security Setup from the AMIBIOS Setup main menu. All Security Setup options are described in this section. The Security Setup screen is shown below. Supervisor Password User Password AMIBIOS provides both Su…

53, 3-5 Chapter 3: Troubleshooting BIOS is not in control such as during memory count (the first screen that appears when the system is turned on), the momentary on/off switch must be held for more than four seconds to shut down the system. This feature is required to implement the ACPI featu…

73, Chapter 4: AMIBIOS 4-19 Power Button Mode This option allows you to change the function of the chassis power button. The settings are On/Off and Suspend. When set to Suspend, depressing the power button when the system is up will cause it to enter a suspend state. Suspend Timeout…

31, Chapter 2: Installation 2-7 Front Control Panel JF1 contains header pins for various front control panel connectors. These connectors are designed for use with Supermicro server chassis. See Figure 2-4 for the pin locations of the various front control panel buttons and LED indicators. Refer t…

43, Chapter 2: Installation 2-19 33 MHz PCI Enable/Disable (X5DL8-GG) If you wish to use 33 MHz PCI cards, close J29 to force the P1 bus (slots 2 & 3) to run at 33 MHz. See the table on the right for jumper settings. Note: if you force the slots(s) to 33 MHz, you must set the P1 bus speed jumpers (…