Lexmark CS410 series Technical Reference Manual

3, Introduction PRESCRIBE emulation option for Lexmark laser printers is an extended version of the firmware that includes a PRESCRIBE language processor. It enables the printer to be an effective replacement for Kyocera printers in select large accounts where the PRESCRIBE printer language is u…

5, Incomplete command set Most PRESCRIBE II commands are not supported. Some commands are partially supported. For example, the BARC (bar code) command is supported for only a subset of the possible bar code types. One base emulation supported Kyocera printers support a number of base emu…

4, Memorex printer compatibility mode The PRESCRIBE emulation option includes a custom extension to support an alternate font number table which is compatible with Memorex system printers. The font number mapping is as follows: Memorex font number Standard PRESCRIBE font number 11 26 310 …

8, Lexmark CS410 series Command Description Supported PARC 2 in Path, draw ARC Yes PAT select fill PATtern Yes PCRP 2 in Path, Curve to Relative Position No PCZP 2 in Path, Curve to Zero-relative Position No PDIR 2 set Print DIRection Yes PDRP 2 in Path, Draw to Relative Position Yes PDZP 2 in Path, Draw to Zero-re…

19, Fonts Bitmap font simulation The following table lists the Kyocera resident bitmap fonts, and the PRESCRIBE emulation best-fit fonts which are used from the standard set of PCL resident scalable fonts. Selection of any of these fonts results in a compatible match with respect to character spacing an…

13, The odd‑numbered parameters (A1, A3, A5, and A7) specify a whole‑inch value. The even‑numbered parameters (A2, A4, A6, and A8) specify a fraction in 100ths of an inch. Page Length and Page Width settings that are larger than the default margin limits are ignored. The factory default…