Hardy Instruments Any-Weigh Operation And Installation Manual

47, Index Numerics 304 stainless steel platform 1-4 A About Pit Frames 1-25 Acceptable Tolerance 1-13 Access Ramp Installation 1-29 Accessories 1-2 Active Elements 1-3 Allen Bradley Module Manual 1-11 Approvals 1-2 Attach a Chain 1-3 B Blind Hole Load Introduction Technology 1-3 Bloc…

42, Any-Weigh™ Series Floor Scales 34 FIG. 29 BUMPER GUARD/INSTALLATION Step 2. Drill the holes using a hammer drill. (See Specifications/Anchor Bolt Holds above for hole dimensions) Step 3. Insert the anchor bolts with the nut and washer already installed. Step 4. Tap the anchor bolts into…

41, Any-Weigh™ Series Floor Scales 33 NOTE: If ramps are NOT installed and bolt-down plates are needed, then a set of four (4) bolt-down plates are required. OPTIONAL BUMPER GUARDS Bumper guards are designed to help protect the plat- form from direct hits from forklift traffic. The guards are sli…

27, Any-Weigh™ Series Floor Scales 19 FIG. 14 INSERTING THE LEVELING FOOT INTO THE LOAD SENSOR NOTE: You may need to push with a little force due to some interference caused by the O-ring that is attached to the foot. DO NOT USE A HAMMER OR TRY TO DRIVE THE FOOT INTO THE HOUSING. Step 3. …

11, Hardy Instruments Any-Weigh Any-Weigh™ Series Floor Scales 3 out. The active elements of the floor scales are four precision strain gauge load sensors, mounted on all four corners of the scale platform. The unique Blind Hole Load Introduction technology allows the foot to move to compensate for uneven floors. This …

15, Any-Weigh™ Series Floor Scales 7 FIG. 3 DIRECTION WHEN DRIVING HEAVY EQUIPMENT ON AND OFF THE SCALE FLOOR SCALE INSTALLATION Step 1. Place the platform scale on the operating location. Make sure that the platform height is within 3 to 3.275" as measured from the top o…