DFI G586IPC Operation & User’s Manual

65, 65 Appendix C Connectors Connectors J1 J2 J3 J4 J5 J6 J7 J8 J9 J10 J11 J13 J14 J15 J16 CN1 CN2 PL1 JP1 JP2 PS/2 mouse connector COM 1 serial port COM 2 serial port Floppy disk drive connector Parallel printer port Primary IDE hard disk drive connector Secondary IDE hard disk drive c…

56, 56 System Error Report When the BIOS encounters an error that requires the user to correct something, either a beep code will sound or a message will be dis- played in a box in the middle of the screen and the message, PRESS F1 TO CONTINUE, CTRL-ALT-ESC or DEL TO ENTER SETUP, will be sho…

64, 64 Note: The I/O address hex 0000 to 00FF are reserved for the system board I/O. Hex 0100 to 03FF are available on the I/O channels. I/O Address Map I/O Address Function 0000-001F DMA Controller 1, 8237A-5 0020-003F Interrupt Controller 1, 8259A, Master 0040-005F Timer, 8254-2 0060-006F 87…

25, 25 Connecting the Parallel Printer Port Attach the DB-25 printer port cable to connector J5 on the G586IPC system board. Make sure the colored stripe on the ribbon cable aligns with pin 1 of connector J5. Use a small nutdriver to mount the cable into a DB-25 cutout in the system chas…

26, DFI G586IPC 26 Note: An IDE cable with a standard 40-pin connector (without the keying mechanism) can be installed in the shrouded PCI IDE header. Be ex- tremely careful to match the colored edge of the ribbon with pin 1 of the header. Connecting the Hard Disk Cable 1. Connect the cable to the system …

28, 28 Universal Serial Bus Connectors The G586IPC system board is equipped with two connectors, at loca- tions JP1 and JP2 on the system board, for external USB ports. USB allows data exchange between your computer and a wide range of simultaneously accessible peripherals. Connecting the USB Ports As …