Hiniker 5710 Operator's Manual

28, 26 Service CAUTION: DEATH OR SERIOUS IN- JURY CAN RESULT. ROTORS ARE HEAVY AND SUBJECT TO UNEXPECT- ED MOVEMENT. SECURELY BLOCK UNDER- NEATH THE ROTOR END BEING SERVICED TO PREVENT DROPPING OR SHIFTING BE- FORE AN END BEARING IS REMOVED. 2. Remove (4) 3/8” bolts …

13, TITLE Field Preparation 11 FIELD PREPARATION WARNING: DEATH OR SERIOUS INJU- RY CAN RESULT. BEFORE FIELD PRE- PARING, READ SAFETY-GENERAL, BEFORE OPERATION, DURING OPERATION AND TOWING AT FRONT OF THIS MANUAL. TRACTOR IMPORTANT: ENSURE TRACTOR P.T.O., AND DRAWBAR CONFORM TO …

47, Hiniker 5710 Assembly 45 FIGURE 92 PHOTO NO. 3227 Lay hood Item 1 as shown in Photo 3231and de- flector Item 2 assembly on handy work surface. Knot nylon rope Item 9 on arm Item 4 and thread thru porcelain eyelet. FIGURE 93 …

3, TITLE To The Purchaser 1 TO THE PURCHASER This product is designed and manufactured to give years of dependable service, when prop- erly maintained and used for the purpose for which is intended. Never allow anyone to oper- ate this equipment until they fully unde…

37, FRICTION AND OVERRUNING CLUTCH PHOTO NO. 3999 1. See dismantling and assembly instructions for QC-lock on page 30. PHOTO NO. 4000 2. It is not necessary to remove the torsional spring when replacing the friction disks. PHOTO NO. 4001 3. Tighten the 6 nuts of the spring pack…

46, 44 Assembly 3. Install (8) 5/16” x 3/4” carriage bolts, lock washers, and nuts along bottom (6) of upper chute panel. FIGURE 89 PHOTO NO. 3228 1. With drifts on each side at Items 1 & 2 as shown in Photo …