Singer 82387 Instruction Manual

8, Table of Contents Previous Page | Next Page 8 82387 No. 66 To Replace the Bobbin Hold the bobbin between the thumb and fore- finger of the left hand, the thread leading on top from the right toward the left, as shown in Fig. 7. Place the bobbin into the bobbin case and draw the thr…

26, Table of Contents Previous Page | Next Page 26 82387 No. 66 TUCKER Remove the presser foot and attach the tuck- er in its place. The width of the tuck is deter- mined by the scale of figures nearest the needle, which shows in eighths and six- teenths of an inch the distance of the e…

20, Table of Contents Previous Page | Next Page 20 82387 No. 66 ADJUSTABLE HEMMER Hemming Remove the presser foot and attach the adjustable hemmer in its place as shown in Fig. 25. This hemmer will turn hems from 3/16 inch to 1 inch wide. The adjustment is made by loosening the thumb sc…

7, Table of Contents Previous Page | Next Page 7 82387 No. 66 To Wind the Bobbin continued... The end of the thread must be held by the hand unti1 a few coils are wound and should then be broken off. Figs. 5 and 6 show the bobbin winder properly threaded and in posi- tion for winding. When su…

15, Table of Contents Previous Page | Next Page 15 82387 No. 66 The Belt. See that the belt is not too tight; it should always be tight enough not to slip. If too loose remove the hook at one end, shorten the belt and rejoin. Machine Working Heavily. If the machine runs hard after standing…

6, Singer 82387 Table of Contents Previous Page | Next Page 6 82387 No. 66 To Wind the Bobbin Release the balance wheel (E, Fig. 3, page 3) by turning the stop motion screw (D, Fig. 3, page 3) over toward you. Place the bobbin on the bobbin winder spin- dle (E, Fig. 6, page 7) and push it up close…