ProBoat HyperSport Owner's Manual

8, 8 Before the rst run of the HyperSport 48, you should check the radio for proper operation and to ensure proper control movement of the rudder and throttle. Also ensure that the antenna on the boat is extended properly and that all batteries are in working condition. The …

6, 6 Receiver Batteries  1. Use a 2.5mm hex wrench to remove the eight 2.5mm hex head screws that secure the radio box cover.  2. Remove the battery holder and install 4 AA alkaline batteries in the polarity shown on the battery box. Note: You may consider upgrading the rec…

18, 18 United Kingdom: Electronics and engines requiring inspection or repair should be shipped to the following address: Horizon Hobby UK Units 1-4 Ployters Rd Staple Tye Harlow, Essex CM18 7NS United Kingdom Please call +44 (0) 1279 641 097 or e-mail us at [email protected]…

5, ProBoat HyperSport 5  1. There are 4 plywood boat stand pieces. The 2 short plywood pieces are the ends of the boat stand.  2. Secure the 2 long plywood pieces of the interlocking boat stand to one end of the short plywood pieces. Repeat with the remaining short plywood pieces.  3. Secure the stand toge…

9, 9 Choking the Engine Close the choke by rotating the small yellow tubing extension. This is not necessary if the engine has recently been operated. Pull-starting the Engine With an assistant holding the boat to the boat stand and bracing the engine with one hand, pull the st…