Kaba Mas High Security Pedestrian Exit Device with Electric Locking Trim Installation Manual

33, 29 Covers Install Chassis Cover 1. Locate the chassis cover and plastic cover insert. 2. Orient the chassis cover as it will be installed, based on door handing, and slide the plastic cover insert into the bottom of the chassis cover. 3. Position the chassis cover over the Rim Exit …

27, 23 4. Place the Dial Hub Locating Gage over the spindle and between the dial hub assembly and the bushing in the dial ring cover. This sets up an initial 0.010 inch end play. 5. Push the dial hub and the spindle assembly toward each other. While maintain- ing a constant pressure on them, SECUR…

20, 16 RDS-2 Specifications • Solenoid rated for continuous duty (with RDS). • Input voltage required: 115 VAC, 60 Hz, 5 amps to transformer. • Output voltages: - First Device: Terminal #1 and #2; 24V DC impulse; 5V DC continuously after impulse. - Second Device: One second delay after first d…

28, Kaba Mas High Security Pedestrian Exit Device with Electric Locking Trim 24 Attach Back Cover Assembly for Testing 1. Install the back cover assembly with the two mounting screws in order to test the operation of the lock. Do not install the cover lock pin at this time. Caution: Take care to align the connectors and the baffle to the hole in the cov…

26, 22 Note: To avoid unnecessary damage, always make sure that the motor gear is in its proper detent position when inserting the drive cam. If it is not, a pencil may be used to move it to the proper position. This must be done with the lock bolt extended. 3. Slide the spindle thro…

29, 25 INTERFACE HARDWARE, COVERS Cable Assemblies These steps involve attaching the two stainless steel mechanical cable assemblies to the lock and Rim Exit Device chassis, respectively; connecting these cable assemblies; and adjusting the cable length to achieve proper timing of the high securit…