Robe 250 XT Operation & User’s Manual

15, 15 Fans The WASH 250 XT is cooled by free axial fans - two in the projector head and one in the base. The speed of the fan (and of course the noise) can be continuously reduced if very quiet performance is required. By the Control Board using the "FAnS” function you can c…

8, Robe 250 XT 8 4.3 Adjusting beam eangle The Fresnel lens system can be configured in the range between 8° and 22° .To set the desired beam angle,remove the front cover by loosening 2 fasteners on this cover and loose 2 adjusting screws on the Fresnel lens unit and adjust the required beam angle.Tigh…

28, 28 After having calibrated required functions press [Enter] to confirm (or [Mode] to cancel and return to the menu without reset by the "A.rES." function) and use the "A.rES." function in order to write the calibration values to the memory (EEPROM) and to make a reset…

22, 22 Blackout during movement correction The function executes the blackout during the head movement correction (the moving head has lost its right pan/ tilt-position for a short moment). Use the [Up] and [Down] buttons to select "On" if you want to execute the blackout or "…

27, 27 Fixture code The option contains identification code (1-9999) for the fixture, which is used for the master/slave operation. Adjusting the default positions of the colour and CMY By this function you can calibrate and adjust the colour and CMY to their standard/right positions. Use the [Up…