Windhager BioWIN series Operating Manual

18, 18 2. Operation 2.6 Operating phases 2.6.1 Standby During this operating phase, the controls do not transmit requests for heat. The burner is switched off and the boiler temperature setpoint is 0 °C. After an hour in standby mode, the display is shut down fully, only the green LED i…

51, 51 3. Care, cleaning and maintenance 3.11 Cleaning supply container (BioWIN Klassik, Premium and Exklusiv) and feed unit flap (BioWIN Premium and Exklusiv) It is necessary to clean the reserve supply container and/or flap in the feed unit if too much dust has collected or the…

11, 11 2. Operation 2.1.3 BioWIN Exklusiv Version as BioWIN Premium, but in addition with fully automatic heating surface cleaning and ash removal Fully automatic heating surface cleaning: A motor moves the heating surface cleaning system vertically and the heating surfaces remain clean. Fully autom…

26, 26 2. Operation Fig. 57 Boiler cleaning Time Feed operating mode Time profile feed Probe switching Choose Back Confirm the selected “Boiler cleaning” sub-menu by pres- sing the Choose button – Fig. 57. Fig. 58 Has boiler and burner cleaning been performed? Confirm Ye…

24, Windhager BioWIN series 24 2. Operation Fig. 49 Boiler temperature (Operating phases) Info Menu 42 °C 2.8.1 Operator level Pressing the Menu button shows the „Operator level“, „Service level“, „Information level“ and „MES Module 1 “ in the display – Fig. 49. Fig. 50 Operator…

48, 48 3. Care, cleaning and maintenance Fig. 126 BioWIN 100/150 Fig. 127 Fig. 128 BioWIN 210/260 BioWIN 100/150 BioWIN 210/260 Fig. 129 Detail 1 ........... Cleaning tool or cone removal too 2 ........... Guide groove for the lock the Cone in the burner pot 3 ........... Cone 4…