Windhager BioWIN XL Operating Manual

40, 40 2. Operation Fig. 86 Feed start time Start 10:00 pm – save back + “With start time” A time for filling the hopper can be set in the “Time profile feed” menu, if the “With start time” setting is active in the “Feed operating mode” menu (see section 2.8.…

35, 35 2. Operation Fig. 66 Boiler temperature (Operating phases) Lighting ON 107 °F 2.8.1.3 Feed operating mode 1 This menu option sets: – whether the feed is turned off, or – whether the feed should fill the pellet boiler with or with out time control. Turn on the li…

60, 60 4. Troubleshooting Code Display on InfoWIN PLUS Cause/remedy FE 239 Probe switching defective Check the changeover unit. Press Reset. Pellets are not able to feed into boiler. The boiler does not operate. Press the Reset button. If the fault recurs after a reset, inform Windhager Customer S…

23, Windhager BioWIN XL 23 2. Operation 2.5.5 Chimney sweeper function This function aids the performance of legally required emis- sions testing. Note! The chimney sweeper function cannot be started in “solid fuel/buffer mode”. The chimney sweeper function must not be started if an instal…

47, 47 3. Care, Cleaning, and Maintenance 3.3 Care of cladding and keyboard foil Clean the boiler cladding and keyboard foil as needed with a moist cloth. In the event of heavy buildup, use soapy water or diluted suds (do not use strong cleaners or sharp cleaning instruments). 3.2 Cl…

71, 71 5. Spare parts No. Spare part designation BioWIN XL 10 Ash removal cover 046713 20 Scraper 047960 30 Front ash agitator 047496 40 Microswitch retainer 047983 50 Burner 047271 60 Burner seal 047654 70 Motor spacer 012550 80 Flat gearmotor with connection cable 007106 90 Dr…