nilan CTS 602 Manual, Installation Instruction

13, All rights reserved Page 13 of 25 Heating element The unit is prepared for installation of a supplementary heating element. If the element is supplied and fitted by Nilan, it will be activated in the CTS 602 control system. A water or electrical heating element can be retrofitted. T…

8, All rights reserved Page 8 of 25 Guide to performance data, water heating element The table below shows heat production at various supply and return temperatures - at 5°C inlet after the heat pump and before the heating element. Guide to performance data for VPM 120 water h…

11, nilan CTS 602 All rights reserved Page 11 of 25 Heating element, electric (option) The electric heating element is installed by the factory if ordered as an option. If retrofitting an elec- tric heating element, it must be activated in the CTS 602 control system as described on page 13.. �…

20, All rights reserved Page 20 of 25 Restart The Restart menu is used to set the unit for automatic restart in the event of a high/low pressure fault.  The "HP/LP" setting in the Restart menu must not be used for normal operation. Use of the CTS602 panel…

19, All rights reserved Page 19 of 25 Room control The Room control menu can be used to set the regulator for the room temperature. The menu will NOT appear if T7 is selected as the master sensor on the Temp. control menu.  The parameters in the "ROOM CONTROL�…

12, All rights reserved Page 12 of 25 Setting up the CTS 602 control system This chapter focuses on the CTS 602 control system service menu. Daily use of the CTS 602 con- trol system: see the CTS 602 user guide supplied. Use of the CTS602 panel: - press ESC to go one step back …