Leader LT 450 Instruction Manual

5, 8.17 System Configuration ............................................................................................................. 95 8.17.1 Configuring the Ethernet Interface ................................................................................... 95 8.17.2 Configuring the…

11, 1. INTRODUCTION 1 1. INTRODUCTION Thank you for purchasing LEADER’s measuring instruments. Please read this instruction manual carefully to ensure correct and safe operation. If you have any difficulties or questions on how to use the instrument after you have read this …

65, 8. CONFIGURATION 55 8.3.4 ID Character Position You can set the ID character position in the ID POSITION SET configuration screen. Use the jog dial and and keys to set the position. The selectable ID character position range varies depending on the output format. For details, see Ta…

44, 6. OUTPUT PATTERNS 34 6.5.12 Other Patterns Each time you press OTHERS, the waveform type switches in the following order: Demodulation, ANSI Grayscale, Checker, and xvYCC. The waveform types that can be transmitted vary depending on the output format and aspect ratio (see Tab…

151, 12. REFERENCE 141 Setting Values Factory default Preset Startup Init. 33:0.38M9... NEGA / POSI POSI No No No 34:0.98M9... NEGA / POSI POSI No No No 35:1.02MA... NEGA / POSI POSI No No No 36:1.04M9... NEGA / POSI POSI No No No 37:1.30MA... NEGA / POSI POSI…

40, Leader LT 450 6. OUTPUT PATTERNS 30 6.5.4 Step Each time you press STEP, the step type switches in the following order: 10 Step, 15 Step, and 32 Step. These patterns can be transmitted in any format. The step pattern is used to test the transmission system linearity, adjust gradation, and so on. …