Spectra Logic AIT-4 Supplementary Manual

8, Spectra 2K Library AIT-4 Drive Upgrade 8 Attaching the Rear Panel 1. Attach the fan and serial port cables (Figure 14). 2. Attach the rear access panel with the two Phillips screws. Setting the SCSI IDs After you have installed the new drive, verify the settings of the SCSI ID switches, loc…

1, Spectra Logic AIT-4 1 Spectra 2K Library AIT-4 Drive Upgrade SPRT-1060-A-092004 The Sony AIT-4 drives double the Spectra 2K library’s capacity and transfer rate. Review this document for information about AIT-4 and about upgrading your library to take advantage of AIT-4 drive technology. • Preparation, bel…

2, Spectra 2K Library AIT-4 Drive Upgrade 2 Loading the Firmware Code Tape To load the firmware tape: 1. Drives are located at the bottom of the library. Move the picker away from its lowest position, so that you can access the drives: • Open and close the library door, which forces the picker to …

4, Spectra 2K Library AIT-4 Drive Upgrade 4 2. Unplug the fan and serial port cables inside the Spectra 2K. Set the panel aside (Figure 3). Removing the Drive 1. Unplug the SCSI ID cable and the power supply cable from the library and drive (Figure 4). 2. Unplug the SCSI ribbon from the drive (Fig…

3, Spectra 2K Library AIT-4 Drive Upgrade 3 Resetting Original Values 1. Turn off the power to the library. 2. Use a small screwdriver to return the configuration switch to the default position of 0 and the library SCSI ID to its original setting. 3. Reconnect the SCSI cable to the back of th…

10, Spectra 2K Library AIT-4 Drive Upgrade 10 Sony AIT Tape Drive Specifications The following table summarizes the specifications for Sony AIT drives. LED Information The following table summarizes the information carried by the drive’s LEDs: Parameter AIT-1 AIT-2 AIT-3 AIT-4 Ambient …