Symmetricom TimeProvider 1000 Operation & User’s Manual

49, 097-58001-02 Revision C – August 2005 TimeProvider User’s Guide 49 Chapter 3 Installing the TimeProvider Getting Started  Use only shielded cable for all signal wiring, including I/O, clocks and Ethernet, and ground appropriately at both ends, or as required by local standards.  S…

73, 097-58001-02 Revision C – August 2005 TimeProvider User’s Guide 73 Chapter 3 Installing the TimeProvider Installing Connections to the Ethernet Port Changing Communications Settings To change the communication settings for the local or remote serial ports: 1. Connect a PC or laptop…

13, 097-58001-02 Revision C – August 2005 TimeProvider User’s Guide xiii How to Use This Guide This section describes the format, layout, and purpose of this guide. In This Preface  Purpose of This Guide  Who Should Read This Guide  Structure of This Guide  Conventions Used in This …

113, 097-58001-02 Revision C – August 2005 TimeProvider User’s Guide 113 Chapter 4 Provisioning the TimeProvider Provisioning the Outputs Autonomous Message TP-SSU 03-10-24 11:11:18 A 1190 REPT EVT “OUTA,EQPT:NA,FRMTYPE,NSA,03-10-24 11-11-18:\"RTMSTATE HAS CHANGED,ENABLE\�…

64, Chapter 3 Installing the TimeProvider Making Connections 64 TimeProvider User’s Guide 097-58001-02 Revision C – August 2005 Figure 3-16. DB-25 Alarm Connector (Front View) Making GPS Connections To connect a GPS signal to the TimeProvider, you must install a GPS antenna and the TimePr…

17, Symmetricom TimeProvider 1000 097-58001-02 Revision C – August 2005 TimeProvider User’s Guide xvii How to Use This Guide Related Documents and Information Other helpful documents and software tools are listed below. See your Symmetricom representative or sales office for a complete list of available documentation. �…