W&T Electronics 57713 Manual 

21, 21 W&T 3.3 Assigning the IP using the ARP command Requirements This method can only be used if the device does not already have an IP address, i.e. the entry is 0.0.0.0. To change an IP address, use one of the other methods described in this section or use the configuration menu ove…

24, W&T Electronics 57713 24 W&T Together with the IP address, the subnet mask and gateway address can also be assigned serially. The entry is separated by commas and follows the IP address. Entering as shown in the following example will assign IP address 172.17.231.99, subnet mask 255.255.255.0 and gateway 1…

40, 40 W&T http://<ip-address>/mib.zip 9.6 FTP Measurement data can be stored directly on an FTP server for archiving and checking. Here you configure the basic settings for the FTP server. 9.7 Socket access You can obtain measurement data directly from the device using a sock…

17, 17 W&T • If the device does not have its factory default settings and there is a system password assigned, this must be known in order to make changes using WuTility. Step 1: Start the assignment dialog WuTility automatically searches the local network for connec- ted W&T …

54, 54 W&T 16 Hardware-Reset to factory defaults A reset of the device to its factory defaults can be done via hardware. For this purpose the device has a jumper on the board. For normal operation this jumper must be out. To set the factory defaults, proceed as follows: • Power off the d…

44, 44 W&T 12 Device information Here you find descriptive information about your device and manufacturer’s descriptions. The contents of this information can be changed in the basic settings under Language/Infos. …