VideoRay Pro 4 Maintenance Manual

15, VideoRay Pro 4 Move joystick to the right (J1 +X) = The crosshair should move to the right Move joystick away (forward) (J1 +Y) = The crosshair should move down Rotate the joystick clockwise (J1 CW) = the bar size should decrease Rotate controller knob on upper left clockwise (RX CW) = the bar size shou…

12, Diagnostics Pro 4 Maintenance Manual, Novice 1.00.00 Diagnostics and Repair Are you having a bad day with your Pro 4? You have come to the right place. Solving problems requires either a methodical diagnostics approach, or lots of luck. If you don't like to gamble, the following ma…

3, Table of Contents Pro 4 Maintenance Manual, Novice 1.00.00 Table of Contents Copyright Table of Contents About this Document How to Get Help User Maintenance Policy Maintenance Best Practices Well Equipped Shop Basic Equipment Care Special Handling ORings Cartridge Seals Example Ca…

8, Cleaning VideoRay systems should always be cleaned after use. When used in salt water or contaminated environments, make sure to thoroughly rinse and then soak all wet components. It is especially important that you rinse the pressure sensor and allow it to drain. You must remove the float b…

9, Cartridge seal with an acceptable bubble  this seal is okay to use. Nearly empty cartridge seal  this seal should have been replaced when the oil level reached 1/2 of the original volume. Cartridge seals like this should not be used. Cartridge seal with contamination  this se…