Sartorius combics 1 Service Manual

26, 26 Zone “D” For a complete scale used in the Federal Republic of Germany, the following data can be entered for scales with a resolution of 3000 digits at the place of span adjustment: – Latitude: 51.00 degrees – Altitude: 513 m – or the corresponding acceleration of gravity,…

84, 84 Replacing Load Cells If an off-center load error is detected (platforms with one load cell), or if the output signal from the load cell is too high or too low (InF 02 is displayed during span adjustment), replace the load cell. Because the mechanical construction of the platforms is basically un…

75, 75 Checking the IP67 Protection The test procedure and the equipment used have yet to be specified. Torque Values for Cable Glands and Vent Valve Cable gland: power cord 3 Nm Cable gland: optional connections 3 Nm (brass: 5 Nm) Cable gland (brass): platform connection 5 Nm Vent valve 1.…

88, 88 Error Codes Error codes are shown on the main display. Err codes are shown continuously; Inf messages are shown for 2 seconds, after which the program returns automatically to the weighing mode. Display Cause Solution Err 101 - 104 Key is stuck Release key or Key pressed at power on Conta…

1, WCI5005-e03104 Service Manual Sartorius Combics 1 | Combics 2 Models CIS1U | CIS2U | CISL1U | CISL2U for Combics Indicators and Models CAPP.U-...-LU | CAPS.U-...-LU for Combics Weighing Platforms including Service Specifications C F REF O K …

41, Sartorius combics 1 41 Example: Entering geographical latitude and elevation: Select menu item 1-20-1 (latitude) (press )). In the example shown here, the most recently entered parameter was the value for the acceleration of gravity (menu item 1-20-3). For this reason, the input fields for menu items 1-20-1 and 1-20…