StorageTek L180 Service Manual

24, Safety xxii Fifth Edition 95897 Lifting Techniques Lifting, regardless of how much or how little, can create serious back stress. If you follow these guidelines, you can reduce the risk of back injury: • Do not twist your body to pick up something or to put it down. Twisting puts …

26, Safety xxiv Fifth Edition 95897 • Periodically check the electrical resistance of the ground cord and the wrist- strap coil cord. Note: The ground cord should measure less than 1.2 MΩ, and the coil cord should measure between 0.8 and 1.2 MΩ. Repair or replace the cords if th…

196, Super DLT 4-106 Fifth Edition 95897 ■ Super DLT WARNING: Electrocution hazard. Do not touch any components on the power supply located within the electronics module or on the drive trays. Live voltage could be present even though the unit is powered off. Do not apply power…

113, 95897 Fifth Edition 4-23 Cartridge Access Port Motor 12. Grasp the CAP by the magazine shelf, and pull the CAP off of the top and bottom alignment pins. 13. Lay the flat side of the CAP on the corner of a flat surface. 14. Use a T-25 Torx bit to remove the cable clamp screw. 15. Open the cl…

237, StorageTek L180 95897 Fifth Edition A-11 Robot Theta Assembly The theta assembly is composed of the +43 V theta motor, the PRY card, and the theta drive belt. The theta assembly, under microprocessor control by the MPC card, moves the hand laterally within the library. A closed-loop servo fee…

63, 95897 Fifth Edition 2-19 Configuration Overview Setting the Library Name The system administrator might assign the library a name. The name is mapped to the IP address but does not affect operation. To set this value: 1. At the Network Config Menu, press an arrow button until the cur…