Carf-Models DG 800 S Instruction Manual

17, Carf-Models DG 800 S Wing Servo Installation The wings are completely finished. The slot cover tape is attached, control horns are installed and the speed brake cover is precisely attached. …

24, Gear door and retract installation Mount the wooden servo mount with the M4 x 12 allen bolts to the aluminum frame of the retract. As usual, use the 2.9 mm sheet metal screws and washers to mount the servo in the frame. As linkage use the M3 all thread and two spring steel clevises. You…

7, Liste Der Enthaltenen Bauteile Material Name Piece For What Threaded end M3 with hold for steel cable 2 Ruder PULL PULL WIRE DIA 0.8MM 2 x 2 Meter Ruder CRIMP TUBES DIA 2MM 4 Ruder Clevis M3 2 Ruder ALLEN SCREW M 3*12 2 Ruder WASHER M3 6 Ruder SHEET METAL SCREW 2.9*13 4 Ruder hinge wire 2mm…

25, Slide the retract unit into the slots of the two formers and secure it with the two wood boards, bolted on with each two of M3 x 16 allen bolts, as shown on the photos above. Gear door and retract installation …

22, Wing attachment For the wing servo wire connection we recommend to use larger connectors. You can glue 2 against each other. There are many ways and preferences, you might have your own style. It is important that the wires don’t rub against the edges of the cut-outs. The “f…