Adaptec ASA-7211C/F Installation Manual

44, B-1 B LEDs You can use the adapter LEDs to diagnose problems during system startup and as speed indicators during normal system operation. The following tables describe the LED functions. LED Diagnostics Definitions D0 D1 Definition Off Off Power-on Self Test (POST) failed. Flashing Of…

37, 5-6 ASA-7211C/F Installation Guide Using Express Setup to Configure the iSCSI Adapter Now that you have started iConfig, you are ready to run iConfig Express Setup to configure the adapter (initiator). Note: In any menu, press Esc to get back to the previous menu. When you run i…

20, Adaptec ASA-7211C/F 3-5 Installing the Driver in Existing Systems The driver has been installed. The system does not require rebooting. To verify the driver installation, open the Device Manager and view the driver, as shown below. When you are finished installing the driver, proceed to Chapter 5, Configuring the i…

28, 4-3 Creating an iSCSI-Bootable System 6 To create a single boot target entry, select Target Configuration > Add Targets and press Enter . a For the target name, choose one of the following: ■ Type iSCSI as the target portal name. (recommended) ■ Leave blank, and the utility au…

22, 3-7 Installing the Driver in Existing Systems Installing the Linux Module This section contains the following procedures: ■ Installing the Module Using the RPM Package ■ Installing to the Module Using the .tar.gz Package For additional Linux functionality, such as enabling multiLUN su…

27, 4-2 ASA-7211C/F Installation Guide Configuring the iSCSI Adapter BIOS Overview Configuring the BIOS involves the following tasks: 1 Optional—Configure the initiator by entering the iSCSI initiator name (iqn name), initiator IP address, and initiator subnet mask. 2 Configure a single …