Bard WH301 Installation Instructions Manual

8, Manual 2100-193 Page 6 FRESH AIR INTAKE All units are built with fresh air inlet slots punched in the service panel. If the unit is equipped with a fresh air damper assembly, the assembly is shipped already attached to the unit. The damper blade is locked in the closed position. To allow the …

5, Manual 2100-193 Page 3 TABLE 1 ELECTRIC HEAT TABLE sledoMA-103HWB-103HWC-103HWA-163HWB-163HWC-163HW 1-0421-8023-0423-8023-0641-0421-8023-0423-8023-064 WKAUTBAUTBAUTBAUTBAUTBAUTBAUTBAUTBAUTBAUTB 58.02560711.81008218.02560711.8100821 016.14031432.63006526.14031432.6300652 51 5.2…

6, Manual 2100-193 Page 4 MIS-1262 FIGURE 1 UNIT DIMENSIONS FRONT VIEW BACK VIEWSIDE VIEW * Optional top outlet (factory installed only) for WH30 and WH36 models only. TABLE 2 DIMENSIONS OF BASIC UNIT (Nominal) ledoM htdiW )W( htpeD )D( thgieH )H( ylppuSnruteR EFGIJKLMNOPQRSTABCB 03HW 63…

19, Manual 2100-193 Page 17 IMPORTANT INSTALLER NOTE For improved start-up performance, wash the indoor coil with a dishwashing detergent. CRANKCASE HEATERS All units are provided with some form of compressor crankcase heat. All single and three phase models have an insertion well-type…

17, Bard WH301 Manual 2100-193 Page 15 COMPRESSOR CUTOFF THERMOSTAT AND OUTDOOR THERMOSTATS Heat pump compressor operation at outdoor temperatures below 0° F are neither desirable nor advantageous in terms of efficiency. Since most equipment at the time of manufacture is not designated for any…