Ambirad VSUS Owner's Manual

9, 1.6 Electrical Connections This appliance must be electrically grounded Supply 120V 60Hz single phase. Standard heater 0.16HP. Current rating 1.2 amp max (inductive). Fuse: external 3 amp. Important: All electrical work should be done by a qualified electrician in strict accordance wi…

44, Check installation has been carried out to these instructions. NO YES Ensure gas and electricity supplies are isolated. Disconnect gas hose from burner Remove burner from tube and inspect burner head. (See servicing instructions) Replace burner on tube and secure. Open control …

20, 20 2.2.3.4 Linear - 4” SL Tube Heaters  Type ‘A’ is a fixed reflector suspension bracket, tabbed with reflector fixing points. This bracket is ALWAYS closest to the burner.  Type ‘B’ is a sliding reflector suspension bracket and NOT fastened to the reflector. …

30, 30 Figure 15. Heater Assembly: Model U tube 170U55 and 200U55 6' 0" REFLECTORS TYPICAL OF 5 6½" 5' 8" 5' 5" 29' 0" NOMINAL OVERALL ASSEMBLED LENGTH A2 5' 9" B2 B 4' 2" MAX 4" x 10' TUBE TURBULATOR 4&qu…

53, Ambirad VSUS 7.3 Gas Valve Replacement Step 1: Remove the burner assembly as described in section 4 (Servicing). Step 2: Open the right hand access door and disconnect the burner controller from the wiring harness. Step 3: Open the left hand access door and detach the impulse hoses …

18, 18 2. Assembly Instructions. 2.2.2 Turbulators All models include a turbulator or a set of turbulators. Carefully insert turbulator(s) inside the tube up to the end tab. 2.2.3 Brackets 2.2 Assembly Notes. 2.2.1 Tubes Each heating unit has two types of emitter tubes. Se…