DFI Q7-100 Operation & User’s Manual

19, www.d.comChapter 2 Hardware Installation 19 Chapter 2 LVDS LCD Panel Connector LCD/Inverter Power Connector The system board allows you to connect a LCD Display Panel by means of the LVDS LCD panel connector and the LCD/Inverter power connector. Thes…

27, www.d.comChapter 2 Hardware Installation 27 Chapter 2 USB Client Connector The USB client connector supports 1 port (1 USB device controller with 1 port) and high-speed (480Mbps) and full-speed (12Mbps) operations. It complies with USB 2.0/1.1 protocols. 1 4 USB device detect USB dat…

21, www.d.comChapter 2 Hardware Installation 21 Chapter 2 The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se- rial ATA cable to a SATA connector and the other end to your Serial ATA device. SATA (Serial ATA) Connectors SATA 0 SATA 1 7 1 TXN GND RXP…

11, DFI Q7-100 www.dfi .comChapter 2 Hardware Installation 11 Chapter 2 Backlight Control Level Select 1 3 2 1 3 2 2-3 On: +3.3V 1-2 On: +5V (default) JP15 is used to select the backlight control level +5V or +3.3V. JP15 MXM 5V Power Select 1-2 On: 5VSB 64 2 531 64 2 531 64 2 531 3-4 On: 5V 5-6 …

23, www.d.comChapter 2 Hardware Installation 23 Chapter 2 Power Connectors Use a power supply that complies with the ATX12V Power Supply Design Guide Version 1.1. An ATX12V power supply unit has a standard 24-pin ATX main power connector that must be inserted into the 24…

3, www.dfi .comChapter 1 Introduction 3 Table of Contents Copyright .............................................................................................................2 Trademarks ........................................................................................................2 FCC an…