DRS Technologies Tamarisk 640 Operation & User’s Manual

19, Tamarisk ® Camera Control Software User Guide 15 Figure 17. DRS No Attached Devices Found Select the camera from the pull-down menu or select “Auto Detect Device.” Additionally, the user may select the COM port and Baud rate. The default baud rate for conne…

54, Tamarisk ® Camera Control Software User Guide 50  If using a DC power supply to power the camera, verify that the power supply is on and supplying the correct voltage and is capable of sourcing enough current. • Symptom: A continual audible shutter click is heard when t…

39, Tamarisk ® Camera Control Software User Guide 35 Figure 40: Cold Target The Camera Control Software application will send setup information to the camera and command it to start collecting cold target data. Several frames are integrated together to reduce noise and pr…

2, DRS Technologies Tamarisk 640 Tamarisk ® Camera Control Software User Guide i ©Copyright 2013, DRS TECHNOLOGIES, Inc.- All rights reserved. 13532 N. Central Expressway Dallas, TX 75243 877.377.4783 www.drsinfrared.com All rights reserved. The contents of this document may not be reproduced in wh…

45, Tamarisk ® Camera Control Software User Guide 41 Cursor Color Change / hotkey Toggles the color of the cursor between white and black. This helps the user see the cursor when looking at a hot or cold scene. Mark Pixel + hotkey Marks the current pixel for substitution Un…

38, Tamarisk ® Camera Control Software User Guide 34 5.7.5 Lens Calibration - Selecting a Table to Store your Data 7. Next, select the location to store your calibration. During the calibration process, lens “correction coefficients” are calculated and saved to the camera, via…