Lexmark M5150 Service Manual

756, 3 Release the E-clip securing the lowermost gear. Remove the spacers, and then pull the gears off the machine. Sensor (bin full send) removal 1 Remove the finisher right cover. See “Staple, hole punch right cover removal” on page 741. 2 Remove the two screws (A) from the sensor. 4063 Rep…

138, Error code Description Action 456.85 Staple, hole punch finisher: Stapler unit jam while stapling—unable to return to home position Go to “Stapler carriage (HPU) jam service check” on page 193. 456.86 Finisher/offset stacker: Stapler cartridge empty— unable to staple Go to “Stap…

497, 4 Disconnect the cable (C) from the controller board, and remove the main cooling fan. Main drive motor removal Installation warning: When replacing the main drive motor, make sure that the control panel door is in the closed position or the main drive motor will not align properly, and damage wi…

68, 8 Insert the cartridge into the printer, and then push the green handle back into place. Notes: • Align the arrows on the guides of the toner cartridge with the arrows in the printer. • Make sure the cartridge is fully pushed in. 9 Close the multipurpose feeder door and the front cover. 10…

926, Lexmark M5150 P/N Part name Page 40X7594 Main drive motor...................................................................................................................................816 40X7595 Fuser drive motor (belt fuser printers only)........................................................…

413, 13 Remove the toner level contact. 14 Remove the screw (B) securing the transfer roller right arm to the machine. 4063 Repair information 413 …