Minuteman Pro Series Owner's Manual

4, 4 2 CONTROLS AND INDICATORS Press and release the on/off/test button after one beep to turn the unit on or off (see section 4) The online/on battery/boost and buck LED illuminates in a steady state when the UPS is on and supplying AC power to the load, blinks and sounds t…

12, Minuteman Pro Series 12 115 (230) VAC 50 or 60 Hz, +/-0 Hz, unless synchronized to utility during brownout Simulate sine-wave Overcurrent and short circuit protected, latching shutdown on overload 8 SPECIFICATIONS 3 to 6 years, depending on the number of discharge cycles and ambient temp. 2 to 5 hours f…

13, 13 Pro Series Date of manufacture 1826 Enabled Enabled UPS output 92 VAC (176 for 230 VAC models) Use this function to uniquely identify the UPS in your net- work configuration Enter the current date when replacing batteries When enabled, the UPS will automatically restart from a low battery sh…

5, 5 INSTALLATION PLACEMENT Install the UPS in a temperature controlled environment that is free of conductive contaminants. Select a location which will provide good air circulation for the UPS at all times. Avoid locations near heating devices, water or excessive humidity, or where the UPS…

1, 1 1 © Copyright Para Systems, Inc., 1996 TABLE OF CONTENTS Pro Series Owner's Manual 1. Introduction 2 2. Controls and Indicators 4 3. Installation 5 4. Operation 7 5. Troubleshooting 8 6. Replacing the Battery 9 7. Obtaining Service 11 8. Specifications 12 9. Configurable Para…

7, 7 LOW BATTERY WARNING ALARMS ON BATTERY When the UPS is operating on the batteries the on-line LED will blink and the audible alarm will sound every 10 seconds. The alarm will stop once the UPS returns to on-line operation. UPS FAULT When the UPS detects a hardware fault the fault LED will …