Pressure Seal Systems PS400 Operator's Manual

50, Form Specification Sizes W 170mm (6.7in) x L 100mm (4in) minimum W 300mm (11.8in) x L 432mm (17in) maximum Cut-sheet Fold Configuration Z, V and C folds Conveyor Specification Construction Steel Size 515mm (L) x 335mm (W) Weight Approximately, 13kg Power 110/230V AC ±10% 0.5A…

25, Pressure Seal Systems PS400 3. Set-up PS400 Iss. 1. Page 17 Second Fold Plate (no fold) Leading Edge Fold Perforation First Fold Plate First Fold Dimension First Fold Dimension Setting Locking Knobs 150 6 5 140 130 120 Figure 8: V Fold Set-up …

33, 4. Operation General This section explains in detail how to: • Load forms • Start up and test the machine • Process forms Any problems that arise from the operation of the machine are addressed in the next chapter, which includes a troubleshooting guide. Operating process O…

14, If the machine is damaged Switch off the machine's power, unplug it from the mains and refer servicing to an authorized service representative under the following conditions: q If the mains lead is damaged or frayed q If liquid has been spilled into the machine q If the machine has been exposed…

26, C fold set-up Refer to Figure 9. 1. Measure the length of the folds required. 2. Adjust the form stop for each fold plate to the measurement you determined previously in step 1 as follows: Loosen the locking knobs at each end of the form stop. Using the knobs as handles, slide the stop alon…