Pressure Seal Systems PS300 Operator's Manual

46, Condition Possible Cause Corrective Action Forms are wrinkled or badly folded. Forms not feeding squarely against form stop(s). Adjust the form stop(s) to squarely deflect the forms; ensure the stop setting is identical on both scales. See page 16. Dirty fold rollers. Clean fold rollers. Fold plate …

27, 3. Set-up PS300 Iss. 3. Page 19 First Fold Plate Locking Knobs Locking Knobs First Fold Dimension Second Fold Dimension First Fold Dimension Setting Second Fold Dimension Setting Second Fold Plate 150 6 5 140 130 120 150 6 5 140 130 120 Leading Edge Fold Perforations Figure 9: …

28, Z fold set-up Refer to Figure 10. 1. Measure the length of the folds required. 2. Adjust the form stop for each fold plate to the measurement you determined previously in step 1 as follows: Loosen the locking knobs at each end of the form stop. Using the knobs as handles, slide the stop alon…

12, Safety precautions Although the design of your folder/sealer includes safeguards for set-up and operation, you must adhere to the following precautions. I No one should use the machine unless they have been trained to do so. Pressure Seal Systems accept no responsibility for unauthoriz…

47, Pressure Seal Systems PS300 6. Cleaning the machine Cleaning procedure The machine’s folding and sealing mechanisms should be cleaned in the following manner: P To avoid leaving finger-marks on the machine’s internal rollers, it is recommended that disposable gloves are worn during cleaning. People susceptible to dust …