Subaru 2004 Legacy Service Manual

13, CS-12 CONTROL SYSTEMS Select Cable 3. Select Cable A: REMOVAL 1) Set the vehicle on a lift. 2) Shift the select lever to “N” range. 3) Disconnect the ground cable from battery. 4) Lift-up the vehicle. 5) Remove the front, center and rear exhaust pipes and muffler. (SOHC and DOHC…

23, Subaru 2004 Legacy CS-22 CONTROL SYSTEMS MT Gear Shift Lever 14) Remove the cushion rubber from vehicle body. 15) Extract the spring pin and remove the joint. 16) Lower the vehicle. 17) Remove the gear shift lever. B: INSTALLATION 1) Install the joint to transmission and secure with spring pin. 2) Insert the gear s…

9, CS-8 CONTROL SYSTEMS Select Lever Tightening torque: 18 N ⋅ m (1.8 kgf-m, 13.3 ft-lb) 3) Install the harness clips to bracket. 4) Install the console box. <Ref. to EI-53, INSTAL- LATION, Console Box.> 5) Shift the select lever to “N” range. 6) Lift-up the vehicle. 7) Shift the range …

19, CS-18 CONTROL SYSTEMS Shift Lock Solenoid 5. Shift Lock Solenoid A: REMOVAL 1) Remove the console box. <Ref. to EI-53, RE- MOVAL, Console Box.> 2) Disconnect the connector. 3) Shift the select lever to “N” range. 4) Remove the grip. 5) Remove the indicator cover. 6) Remove the blind. 7) R…

29, CS-28 CONTROL SYSTEMS MT Drive Select Lever 7. MT Drive Select Lever A: REMOVAL 1) Place the drive select lever in HI position. 2) Push the both sides of knob, and remove the cover. (Rubber type) 3) Insert a screwdriver with thin tip into the both sides of knob, and push to remove the…

32, CS-31 CONTROL SYSTEMS Drive Select Cable 12) Loosen the nut, and remove the cable from ca- ble bracket. 13) Lift-up the vehicle, and then remove the cable under vehicle. B: INSTALLATION 1) Install in the reverse order of removal. NOTE: • Adjust the drive select cable. <Ref. to CS-31, ADJU…