Subaru 2004 Legacy Service Manual

9, AC-7 HVAC SYSTEM (HEATER, VENTILATOR AND A/C) General Description 2. BLOWER MOTOR UNIT (1) Upper case (6) Control unit (Auto A/C model) Tightening torque: N & m (kgf-m, ft-lb) (2) Intake door actuator (7) Power transistor (Auto A/C model) T: 7.5 (0.76, 5.5) (3) Filter (Auto A/C model) Blower …

571, EI-43 EXTERIOR/INTERIOR TRIM Side Protector 4) Cover the area where solvent is applied using plastic wrap (A), and then heat the double-sided tape for 5 to 10 minutes in 40 — 60"C (104 — 140"F) using a heat lamp (B). CAUTION: Do not heat the double-s…

230, AB(diag)-100 AIRBAG SYSTEM (DIAGNOSTICS) Diagnostic Chart with Trouble Code Step Check Yes No 1 CHECK DRIVER’S AIRBAG MODULE. 1) Turn the ignition switch OFF, disconnect the battery ground terminal, and wait more than 20 seconds. 2) Remove the driver’s airbag module. <Ref. to AB-14, Driver…

166, Subaru 2004 Legacy AB(diag)-36 AIRBAG SYSTEM (DIAGNOSTICS) Airbag Warning Light Failure Step Check Yes No 1 CHECK COMBINATION METER. Turn the ignition switch to ON, and confirm that warning lights equipped in the combination meter are turned on. Do warning lights other than the airbag turn on? Go …

262, SB-14 SEAT BELT SYSTEM Rear Seat Belt 6. Rear Seat Belt A: REMOVAL 1. OUTER SEAT BELT RH ASSEMBLY AND LH ASSEMBLY (SEDAN MODEL) 1) Remove the rear seat. <Ref. to SE-14, REMOV- AL, Rear Seat.> 2) Remove the seat belt lower anchor bolt. 3) Remove the rear quarter trim. <…

362, COM-2 COMMUNICATION SYSTEM General Description 1. General Description A: CAUTION • Before disassembling or reassembling parts, al- ways disconnect the battery ground cable from bat- tery. When replacing audio, control module, and other parts provided with memory functions, rec…