Packard Bell EasyNote F5 Disassembly Manual

21, Packard Bell EasyNote F5/F7 Disassembly Manual Page 21 Removing the Touch Pad To remove the touch pad, first remove the Main Board (see Removing the Main Board ) then perform the following steps: 1. Disconnect the Touch Pad and remove isolator stick on it as shown in Fig. 28 Fig. 2…

22, Packard Bell EasyNote F5/F7 Disassembly Manual Page 22 Removing the Speaker Assembly To remove the Speaker Assembly, first remove the Main Board (see Removing the Main Board) then perform the following steps: 1. Remove the screws holding Speaker Assembly as shown in Fig. 30 …

4, Packard Bell EasyNote F5/F7 Disassembly Manual Page 4 Hazardous Voltage There is hazardous voltage present inside the computer when it is connect to an AC supply, even when the computer’s power switch is off. Exposure to hazardous voltage could cause personal injury. To avoid risk o…

9, Packard Bell EasyNote F5 Packard Bell EasyNote F5/F7 Disassembly Manual Page 9 Removing the Keyboard To remove the Keyboard, first remove the battery (see Removing the Battery), then perform the following steps: 1. Release the keyboard from the base unit by push KB lock with flat screws driver as shown …

18, Packard Bell EasyNote F5/F7 Disassembly Manual Page 18 Removing the Chipset Heat Sink To remove the Chipset heat sink, first remove the Bottom cover (see Removing the Bottom Cover ), then perform the following steps: 1. Unscrew the screws on the Chipset Heat sink and d…

12, Packard Bell EasyNote F5/F7 Disassembly Manual Page 12 4. Release two screws at both side of LCD hinge, remain two outer screws attached. Fig. 15 Removing screws at LCD hinge 5. Carefully separate the LCD Module from the base unit. …