Janome CoverPro 1000CP Service Manual

13, 11 6. Looper Position The distance between the looper point and center of the right needle should be 1.8 - 2.2 mm when the looper is at the right most position. [1] Remove the free arm cover and needle plate. [2] Replace the right needle with the Test Pin 795G-001 (shorter one = 28.8 mm) (1)…

21, 19 13. Motor To replace: [1] Remove the belt cover and rear cover. [2] Remove the setscrews (2) and machine socket (2). [3] Disconnect the motor cords (3) from the machine socket (2). [4] Remove the nuts (4) (120 V) or setscrews (4) (230/240 V) and remove the motor. [5] Install the ne…

14, Janome CoverPro 1000CP 12 6. Needle to Looper Timing When the point of the looper meets with the right side of the needle on the right, the needle bar rises 1.3 -1.5 mm from the lowest position. [1] Remove the free arm cover and needle plate. [2] Replace the right needle with the Test Pin 795G-002 (longer one = 30.24 mm)…

12, 10 5. Looper Height The height of the looper point should be 72.6 - 73.0 mm. [1] Remove the free arm cover and needle plate. [2] Replace the right needle with the Test Pin 795G-001 (shorter one = 28.86 mm) (1). [3] Turn the handwheel toward you to bring the looper (2) to the right m…

19, 17 11. Differential Feed Ratio The main and sub feed dogs should move uniformly together when the stitch length dial is set at 3 and differential feed dial at 1.0. [1] Remove the belt cover. [2] Set the stitch length dial at 3 and differential feed dial at 1.0. [3] Turn the adjust…