Cannon CANTERBURY FREESTANDING Manual, User Instructions

12, 12 Position the four individually numbered logs in the following order on the burner head as shown in figures 15 - 18. The male locating pins in the burner head must engage with corresponding holes in the indi- vidual logs. a) Place log No.1 onto the 2 front left pins on the burner head, ensuring …

11, 11 Gas connection 10. Connect incoming gas supply pipe to 1 / 2 ” compression fitting at rear of appliance. For inlet position see figure 13. Log installation 11. The burner is contained within the burner chamber. Refer figure 14. 12. Carefully unpack the log set. Logs are…

20, 5 Do not modify this appliance. 8. If removed, the glass window must be put back onto the unit prior to operating the heater. 9. Installation and repairs should be performed by a licensed service person only, refer to back of brochure for service number. 10. The appliance should be in…

8, 8 Flame characteristics The heater flame should be stable, no lifting from the burner and the logs should glow after approximately 15 minutes operation on HIGH setting. The heater is a fuel effect unit and is designed to operate with luminous flames and may exhibit slight carbon deposit on th…

22, 3 The Cannon appliance is warranted against defects in materials and work- manship for a period of one, (1) year from its date of original purchase, for residential use in Australia. Warranty service, which includes parts and labour for the replacement or repair of defective parts, is…

1, Cannon CANTERBURY FREESTANDING Cannon This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner USER INSTRUCTIONS INSTALLATION INSTRUCTIONS SERVICE INSTRUCTIONS CANTERBURY FREESTANDING MODELS 24 Part No: F2902 Revision (D) - 2009 Cannon Wiring diagram For service to …