Hand Held Products 3800i Operation & User’s Manual

126, 11 - 4 3800i/3800r User’s Guide Trigger Commands You can activate and deactivate the scanner with serial trigger commands. First, the scanner must be put in Manual/Serial Trigger Mode either by scanning the Manual/Serial Trigger Mode bar code (page 3-3), or by sending the Manual/ Serial Me…

104, 7 - 28 3800i/3800r User’s Guide Plessey Message Length Scan the bar codes below to change the message length. Refer to Message Length on page 7-2 for additional information. Minimum and Maximum lengths = 4-48. Minimum Default = 4, Maximum Default = 48. RSS-14 < Default All RSS-14 …

148, 12 - 8 3800i/3800r User’s Guide Standard Cable Pinouts Serial Output 10 Pin RJ41 Modular Plug connects to the scanner handle 1 2 Cord shield 3 Prog 1 (Tied to supply power for primary cable) 4 Supply ground 5 Receive data - Serial data to scanner 6 Transmit data - Serial data from scanner 7 Sup…

145, 3800i/3800r User’s Guide 12 - 5 Standard Cable Pinouts Laser Output Only (Laser Compatible Bar Image) 10 Pin Modular Plug connects to the scanner handle 1 Turn on good read or LED beeper 2 Trigger signal to decoder 3 Laser enable 4 Supply ground 5 6 Digital bar code data output 7 Suppl…

42, 2 - 12 3800i/3800r User’s Guide Wand Emulation Transmission Rate The transmission rate is limited by the terminal’s ability to receive data without dropping characters. Default = 25 inches/second. Wand Emulation Polarity The Polarity can be sent as standard with black bars…

107, Hand Held Products 3800i 3800i/3800r User’s Guide 7 - 31 China Post Code China Post Message Length Scan the bar codes below to change the message length. Refer to Message Length on page 7-2 for additional information. Minimum and Maximum lengths = 2-80. Minimum Default = 4, Maximum Default = 80. Korea Po…