Pella 81CP0101 Installation Instructions Manual

5, Drill 1/8" clearance hole Double-Hung Jamb 1/4" Double-Hung Head Drill 1/8" clearance hole 1/2" Double-Hung Sill Drill 1/8" clearance hole 1/2" Clad Frame Sill Drill 1/8" clearance hole 1" Clad Frame Head Drill 1/8" clearance hole 1" …

3, Pella 81CP0101 1/4" minimum Sealant 1F Repeat steps C - E for all four sides of the opening. F. Remove any debris, paint or stucco from the exterior face of the existing window frame that will interfere with the new window installation. Clean any dirt or debris from the existing sill and ensur…

1, Part Number: 81CP0101©2012 Pella Corporation INSTALLATION INSTRUCTIONS - INSTRUCCIONES PARA LA INSTALACIÓN CLAD WINDOWS WITH FLUSH FLANGE Lea las instrucciones en español en el reverso Installation Instructions for Replacement of Aluminum Windows in Hard Coat Stucco Applications in arid cl…

8, The exterior frame and sash are protected by aluminum cladding with our tough EnduraClad ® or EnduraClad Plus baked-on factory nish that requires no painting. Clean this surface with mild soap and water. Stubborn strains and deposits may be removed with mineral spirits. DO NO…

4, I. Install wood blocking around the entire opening. The blocking must be the same height as the existing aluminum window frame. The blocking must extend to the interior far enough to provide full support for the sill of the new window, however may extend as far to the interior as d…