Lexmark X422 Setup Manual

58, Lexmark X422 50 Install drivers for network printing • Browse Network Neighborhood. Find the host name of the server and look for the shared name you assigned to the MFP. Step 3: Install the print driver (or subset) on network clients Using the point and print method Note: This method is usua…

27, 19 Prepare the MFP Step 5: Prepare the MFP Raising the paper rest The paper rest holds printed jobs at an angle to keep them from sliding out of the output bin. Unfold the paper rest forward to extend it. …

50, 42 Configure for TCP/IP Verifying the IP settings 1 On the Network Setup Page, look under the “TCP/IP” heading and make sure the IP address, netmask, and gateway are what you expected. Note: On Windows computers, click Start Æ Programs Æ Command prompt (or Start Æ Pr…

59, 51 Install drivers for network printing Using the peer-to-peer method With this method, the print driver is fully installed on each client computer. Network clients retain control of driver modifications. The client computer handles the print job processing. 1 Click Start Æ Settin…

39, 31 Load media 2 Pull out the extension. 3 Unfold the extension. Note: If you are loading envelopes into the multipurpose feeder, do not extend the tray all of the way. This may cause envelopes to feed incorrectly. 4 Slide the width guide all the way to the right. 5 Flex the sheets back and …

61, 53 Install drivers for network printing in Print Center and repeat “Step 1: Install a custom PPD file” on page 51. Using IP Printing Follow these steps to create a print queue using IP Printing. To create an AppleTalk print queue, see “Using AppleTalk” on page 52. 1 Open Finder, cl…