Lexmark CS410 series Operation & User’s Manual

169, Cannot detect internal option Action Yes No Step 1 Turn off the printer, then wait for about 10 seconds, and then turn the printer back on. Does the internal option operate correctly? The problem is solved. Go to step 2. Step 2 Check if the internal option is properly installed in …

1, CS410 Series User's Guide September 2012 www.lexmark.com Machine type(s): 5027 Model(s): 410, 430 …

36, Loading the 250‑ and 550‑sheet tray The printer has one 250-sheet tray (Tray 1) with an integrated manual feeder. The 250-sheet tray, the 650-sheet duo tray, and the 550-sheet tray support the same paper sizes and types and are loaded in the same way. CAUTION—POTENTIAL INJURY: To reduce the …

162, Lexmark CS410 series Try one or more of the following: • Install the missing imaging kit. For more information, see the “Replacing supplies” section of the User’s Guide. • Remove the unresponsive imaging kit, and then reinstall it. Note: If the message appears after reinstalling the supply, th…

43, One‑sided printing using a letterhead Two‑sided printing using a letterhead ABC ABC • Load envelope with the flap side up and against the right side of the paper guide. 2 Feed paper into the manual feeder only to the point where its leading edge can contact the paper guides. Not…

151, [x]‑page jam, clear manual feeder. 1 Pull out the standard 250-sheet tray (Tray 1) and manual feeder. 2 Grasp the jammed paper on each side, and then gently pull it out. Note: Make sure all paper fragments are removed. 3 Insert the tray. 4 From the printer control panel, touch to clear …