MINOURA RS-4000 Instruction Manual

4, MINOURA RS-4000 - 4 - ! 1 To adjust the angle of the Clamp Jaws, loosen the Clamp Knob a few turns, push the Clutch Release Lever and rotate the Clamp Jaws. (see Fig. O) When you complete at your desired angle, release the Clutch Release Lever with confirming the edge of the lever is fully bitten by the teeth o…

1, - 1 - Loosen the Lower Quick Release Skewer and raise up the Upper Frame to open the Leg with sliding down the Lower Bracket until it touches the Frame Stopper. (see Fig. A) RS-4000 Instruction Manual Please read this instruction manual carefully before use. Thank you for purchasing …

6, - 6 - If you wish to clamp the seat post or the seat tube instead of the top tube, adjust the angle of the Clamp Jaws before placing your bike. (see Fig. V) 7 1 Once you had removed the thread of the roll nut in the Clamp Jaws completely by your improper adjustment (Fig. X), you cannot use it any …

7, - 7 - Insert the tip of the bolt to the rear roll nut (may be hidden in the square tubing) and keep this position. (see Fig. AA) This bolt has a special thread that is opposite to the one on farthest part. This system makes both roll nuts come together when you tighten the bolt. 3 (Fig. AA) 4…

5, - 5 - ! ! ! To adjust the Clamp Jaws, turn the small Knob on the Clamp Lever. If you turn the knob in the direction of the counter-clockwise, the jaws will open wider. If you turn the knob in the direction of clockwise, the jaws will be narrower. (see Fig. R) 4 If you wish to clamp the top tube of y…