Digimerge VB300 SERIES Instruction Manual

39, 33 Using the Main Menu RECORD SETUP Use the Record Setup menu to set a recording schedule using predefined programs (0~9). Combine these predefined programs during the week to best fit your recording needs. Figure 10.0 Record Setup menu Press the buttons to select the day. Press the b…

17, MONITOR w/ DVR PS/2 MOUSE Connect the PS/2 mouse to the port on the side panel 11 Mouse Control Mouse Control Menu Navigation Tips and Tricks Use the navigation buttons on the remote control as the primary input for the user interface. The following buttons are frequently used when navigat…

89, Digimerge VB300 SERIES 83 Troubleshooting (cont’d.) Troubleshooting (cont’d.) Error Possible Causes Solutions Mouse not detected by system • Mouse cable is not firmly connected to the system • Firmly connect the mouse cable to the PS/2 port on the side of the system • Mouse is not connected to t…

75, 69 Appendix 6: Connecting a Spot Monitor Appendix 6: Connecting a Spot Monitor Use the Spot port (BNC) on the rear panel of the system to connect a Spot Out Monitor (not included). Spot Out displays the camera channels in sequence. This is useful for a monitor in public view: you…

56, 50 Using the Main Menu E-MAIL Configure options for email notifications. By default, the system is setup to use the free Digimerge DDNS service. Note: To use email notification, you must use a DDNS service. To enable E-mail notifcation: 1. Select SEND E-MAIL and press the buttons to sel…