Standard Horizon GX2360S Owner's Manual

8, GX2360SPage 8 COAXIAL CABLE VHF antennas are connected to the transceiver by means of a coaxial cable – a shielded transmission line. Coaxial cable is specified by it’s diameter and construction. For runs less than 20 feet, RG-58/U, about 1/4 inch in diameter is a good choice. For runs …

58, Standard Horizon GX2360S GX2360SPage 58 Watches for a transmission on CH16 and another selected channel until either signal is received. (Dual watch) NOTE: When the DSC SCANNING feature is enabled (see section 7.3 DSC SCAN), the radio watches for a transmission on CH16, another selected channel, and CH70…

48, GX2360SPage 48 6. After a DSC position request is transmitted, the trans- ceiver remains on channel 70 until position data is received from the polled vessel. 7. When the QUANTUM receives the position from the polled vessel it is shown on the radio display and also transferred to the GPS Char…

40, GX2360SPage 40 7.6.2 Receiving an All Ships Call 1. When an all ships call is received, an emergency alarm sounds. The radio will automatically change to channel 16. 2. Press any key to stop the alarm. 3. Turn the CHANNEL selector knob to see the MMSI of the vessel transmitting the All Ships Call. 4…

56, GX2360SPage 56 9 ENHANCED RAM+ MIC OPERATION When the RAM+ microphone is connected to the QUANTUM, most VHF, DSC, setup menus and PA modes can be remotely operated. The RAM+ Mic sup- plied with 23 feet (7 m) of routing cable and can be extended up to 70 feet (21 m) using three 2…

46, GX2360SPage 46 8. After the GROUP CALL is transmitted, all the radios in the group will switch to the designated channel. 9. Listen to the channel to make sure it is not busy, then key the microphone and call the other vessels you desire to communicate with. 7.8.1.3 Receiving a G…