Tytan DS 512 Operation & User’s Manual

10, 10 tytan Appendix A. SMS Pager mode - monitoring other VSS The DS512 can work in pager mode – sending SMS status information about alarm being triggered in third party VSS. The DS512 can work as a pager for OEM CAN-bus VSS or as a pager for any analogue (OEM or aftermarket…

5, Digital Systems 5 Next, the DS512 enables the GPS receiver. In regular operation, the GPS receiver is disabled and the vehicle GPS position is not known. When the GPS signal is fixed, the SMS will be sent: Use the link to open the online map with …

3, Digital Systems 3 The DS512 is intended to work as a complete VSS integrated in a single unit with a GSM-SMS pager. The operation of DS512 as a VSS is described in chapter 1. The issues concerning SMS paging and GPS localisation are described in chapter 2. The control …

9, Digital Systems 9 ARMING / DISARMING OF THE VSS via SMS (only when DS512 is set to VSS mode) If the DS512 is set to the VSS mode, SMS commands can arm or disarm VSS. DS512 responds with a status SMS. Important! after disarming, the VSS waits for …

7, Tytan DS 512 Digital Systems 7 The confirmation of the command is the SMS with information: Example: sets new VSS PIN 54321, and sets 3 mobile phone numbers which will be notified if the alarm is triggered. The unit responds with SMS confirmation: REMOTE CHECK …