Adaptec 29320-R - SCSI Card RAID Controller Installation Manual

7, 6 Plug the internal Ultra320/160 and Ultra2 SCSI devices to the other cable connectors, starting with the connector at the terminated end of the cable. Connect a power cable from your computer’s internal power supply to each internal SCSI device. Connecting Wide SCSI Devices Connect inte…

14, This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Europe…

8, 7 Plug one end of the cable to the Wide SCSI connector on the Adaptec SCSI Card 29320. Plug the other end of the cable to a terminated Ultra/Fast Wide SCSI device. If you have other Ultra/Fast Wide SCSI devices, attach them to the connectors between the two ends of the cable.…

3, 2 Discharge any static electricity build-up before handling your SCSI card by touching a grounded metal object (like the exposed metal parts on the back of your computer). After you turn off your computer and unplug the power cord, remove the cover from the computer. Locate an unused 64-bit PCI…

5, Adaptec 29320-R - SCSI Card RAID Controller 4 Check the SCSI IDs The Adaptec SCSI Card 29320 and each device you connect to it must have a unique SCSI ID number ranging from 0 to 15 on each channel. No two devices on the same SCSI channel can have the same SCSI ID. The Adaptec SCSI Card 29320 is preset to ID 7 for each channel and sho…