Easymount EM-1200 Product Instruction Manual

9, Easymount EM-1200 9 5. Ensure that as the lm is being drawn over the rollers it is smooth. If it isnt you can apply tension to the lm mandrel by turning the core grip adjustment sleeve apply just enough pressure to remove any airpockets or creases 6. Your document can now be fed into the laminato…

12, 12 Trouble Shooting Problem Solution Take pressure o rollers and drop down loosely into the neutral position. The media will then correct itself and run through smoothly. Media lifting and wrinkling going through the rollers. This is caused by adding too much roller pressure. …

7, 7 Film Loading Pressure sensitive lm (loaded on the top mandrel) 1. Lift the feed tray to the upright position and lock securely. Following the loading diagram on the left cabinet of the machine, pull the lm o the bottom of the mandrel and towards the front of the machine, over the…

14, 14 Problem Media running too tight over the feed tray. This happens when the media is loaded onto the system and fed over the feed tray. Load media on holders supplied with the machine. Solution OR Run media loosely through the machine. OR Run media from the top mandrel at the back o…

1, Product instruction manual Easymount Wide Format Laminators The Easymount has been designed to be user friendly, however we strongly recommend you take a few minutes to read through this manual to ensure correct operation. Keep this manual safe for future reference. …

2, 2 Contents Page 3 - Introduction Page 4 - Safety Instructions and Environmental requirements Page 5 - Control panel and specications Page 6 - Installation of laminating lms Page 7 - Film loading Page 8 - Feeding the lm and cold laminating Page 9 - Cold laminating and Single Hot l…