Dodge 2000 Durango Service Manual

805, To install the wheel, first position it properly on the mounting surface. All wheel nuts should then be tightened just snug. Gradually tighten them in sequence to the proper torque specification (Fig. 5). Never use oil or grease on studs or nuts. WHEEL REPLACEMENT Wheels must be replaced if the…

349, The ohmmeter test lead connections for each test are shown in Antenna Tests (Fig. 3). NOTE: This model has a special coating on the antenna mast which is not electrically conductive. Remove the antenna mast from the antenna base before attempting to perform Tests 1 and 2. NOTE: This model has a two-…

733, Dodge 2000 Durango (b) After disconnection, plastic retainer ring will remain with quick-connect fitting connector body. (c) Inspect fitting connector body, plastic retainer ring and fuel system component for damage. Replace as necessary. (7) Latch Clips: Depending on vehicle model and engine, 2 di…

96, FINAL ASSEMBLY (1) Scrape the residual sealant from the housing and cover mating surfaces. Clean the mating surfaces with mineral spirits. Apply a bead of Mopart Silicone Rubber Sealant, or equivalent, on the housing cover (Fig. 32). Install the housing cover within 5 minutes after applying the …

192, RWAL VALVE REMOVAL (1) Remove RWAL valve harness connector from the RWAL controller. (2) Remove the brake lines from the valve. (3) Remove the valve mounting bolt (Fig. 8) and remove the valve from the bracket. INSTALLATION (1) Position the valve on the bracket and install the mounting bolt. Tighte…

68, FRONT AXLE DRIVESHAFTS TABLE OF CONTENTS page page DESCRIPTION AND OPERATION FRONT AXLE DRIVESHAFTS................18 DIAGNOSIS AND TESTING VEHICLE INSPECTION ....................18 NOISE AND/OR VIBRATION IN TURNS ........18 CLUNKING NOISE DURING ACCELERATION . . . 18 SHUDDER OR VIBRA…